Posted by notjustair on June 12, 2017 at 20:51:39 from (184.191.48.136):
I'm using a 30 foot JD 630 disk and 42 foot JD 1010 cultivator for tillage. I pull both with an 8430. The cultivator is about 50 years old (literally) and old technology. When the vertical tillage tools started popping up I thought it was just another way of cultivating but today I realized I'm probably behind the times. I didn't want to go deep and dry things out but there were lots of large weeds in the field I planted today. Instead I cultivated it twice to get the job done and then planted it. That's three passes over the same 110 acres. The VT's I have seen are set up like a disk but without concave blades and are followed by rolling baskets. I had been worried the baskets would pulverize things too much, but the field I planted today was what got me thinking. In places those two tillage passes made powder out of the soil, and in places the tine harrow on the back did nothing to break up the clods. I'm a little worried about soil contact in a few places.
I'm just wondering if anyone has gone from a field cultivator to a VT tool and how they like it. I know the disk isn't leaving. I have to keep it for when things get too woolly before I get in to burn down. About 400 of my crop acres do best with tilling and the other 400 do well no-till. I'm just thinking a VT might do a better job on the fields where I could get by with one pass.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
