I worked for Tractor Supply for about 3 months about 9 years ago. I won't say which store, but it was in NC. I started out at $8 per hour. which would be a maximum of about $16,000 a year. No overtime never ever.
Since I had been a little manager on my last job, in a month they made me something called a 'Team Leader'. And raised my pay to $8.50/hour. About 17,000 a year, if I had stayed a year.
Being a team leader, I was expected to close the store every night, ride heard on the other workers-most had been there longer than me and really knew more about how the store operated than I did. And some of those boys were less than 18 years old. And I had to count the cash drawers and make sure the place was locked up each night. (All this extra responsibility for an extra $20 a week in my paycheck.)
When I quit I had worked 7 consecutive Sundays. Even the ones I was supposedly 'off' I had to go back in to work for a store meeting.
And the day before I quit the spring sale stuff had come in on the truck(s). I went in at 12:00 noon we put up stock and left at 2:00 the following morning, not done yet, and was scheduled to be back at work at 12:00 noon that day. It was also the 7th consecutive day that I had worked an 8 hour shift. And when they finally mailed me my paycheck, there was no overtime in it. (Although that may have been just on account of how they figured their work weeks.)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
