Have been going to different chiropractors over the last plus 40 some years. And if not for them if I would even still be living I would be completely paralized and unable to even feed myself. And all worked off exrays taken right off the start before doing anything, I have had that siatica nerve problem different times as well as my late wife. We both had it to where we could barly move using 2 canes and the other helping to get into the car. After they got done working could walk out without any help. Yes it still hurt for a few days for the damage to heal that it did to the body before we could get there. And before I was even married that would have been 39 years this past Jan I got it in my back and neck so bad I could not move my arms from my sides and ended up with first one and I was in his office 5 days a week for 4 weeks before I was able to get out and do any work. I had worked the first field that spring and got to plant the last field. When I would go in I could not move my arms from my sides and after he was done with me for the day I could raise my arms over my head so I know it did me good. If I had continued with the family medical Dr. before they would have found my spinal cord was about cut off I would have been paralized with not even being able to feed myself. They were treating me for artheritis when it was the spinel cord being mashed between 2 vertebra.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
