Posted by bcny on May 29, 2017 at 17:41:11 from (47.18.252.41):
Looking for advice. My Ford 3000 diesel has a dented up steel oil pan. Should hold 8 quarts (says my manual), only holds 6 1/4 to full mark.
Should I fix that? Well just having dented parts bugs me. And the replacement oil pans are cheap. If I can find it, would a cast iron pan be better?
And oh, tractor was like that when I got it in march, I didn't do it.
What kind of task is a Ford 3000 Diesel oil pan replacement. I don't have a service manual, it looks easy, flat all around no tricky stuff at front and rear bearings. Is this so?
Oil pressure is 72 psi cold, down to 61 psi when hot. This seems good to me. I was kicking around idea of Plasti-Gaging the bearings when the pan is off. I have given up that idea. I might cause more trouble than worth. I have not touched a main or rod bearing in years, and never on my back with engine installed. But are there any non-destructive checks I could perform while the pan is off? I could check crank shaft and rods end play. Is there a wiggle test for loose rod bearings? Is it possible to shim gauge test sleeve to piston clearance? The tractor has a lot of blow by, maybe that is normal for the 3 cylinder Fords. I would check to see if oil pickup tube has been bent also.
So leave it alone with dents and almost 1/2 gallon short on oil, or fix it? If fix it, what else to check while in there?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.