Bingo, most carb equipped vehicles are now new cars after they were recycled.
Now go look up the flat rate time on that quadrajunk. By the time you pay the flat rate you could pay for a reman and installation and have some change left over.
And as was stated. Why spend time and money training for a system you most likely will never work on. One son in law graduated auto tech about 16 years ago. They had two days (about 6 hours total) of carb theory. That's it. Most vehicles went over to fuel injection in the 80's. Sure the throttle body units looked similar to a carb but were a cheap type of fuel injection.
And the same thing is true with trannies and engines. Sure they learn to rebuild them in school but it's cheaper to R&I a reman for the customer and the shop doesn't have to eat the rebuild if it fails under warranty.
Some of these kids today are actually pretty good mechanics but they are not allowed to rebuild a starter or alternator. Heck some of us remember rebuild master and brake cylinders. That's gone too but for liability reasons.
Times change guys, we have to change with it or get left behind.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
