Posted by jeffcat on May 04, 2017 at 21:43:23 from (50.207.7.234):
In Reply to: Homelite 3 posted by Bkpigs on May 04, 2017 at 21:11:25:
I like how to make your own pump primer. Pretty slick. I hate thin mixes and old school motor and gas mixes. All of my old saws and generators come that era right up to today I run with a fairly stiff mix. Take 3/4 of a gallon of hi-test and a bottle of sthil, or husqvarna, ect. Two cycle mix. This will give you a 36 or so to one mix. Much better for the lube factor in the engine. The synthetic oils work fantastic and will not smoke. Run everything from a brand new Huskvarna chain saw to antique Mc Culloch mac 15 ,650,740 etc. Monsters. Never had any carbon build up problems at all ecause the synthetic works so well. That 40 or 50 to one is for the birds and an EPA joke!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.