I have a Priefort gate that is either automatic or manual. I haven't used it much because I sold cows and had other things to spend money on for a while. I don't remember the model number on mine, but it was over $900 new several years ago. It also works quite well manually, haven't experimented enough on the automatic system.
A friend gave me a chute an homemade gate, made from heavy pipe. I discarded the gate part and mounted the Prifert in place. This chute was used open to the ground. Not liking that I welded supports in and floored it with oak boards. My observation is that with the open bottom a cow caught in the headgate and struggling will try to lift the whole gate and chute. With a floored working chute the struggling cow will be working against itself. I didn't have any problems with the calves moving or getting out. I did weld some additional pipe in the sides.
I would not trust portable corral panels to hold cows in the working portion behind the headgate.
Another system I have seen used is to mount the headgate to large posts set deep in the ground and build the working area of more posts and hardwood planks.
On my head gate I release the cow by opening the gate full width and sent the cow out the front. There can be problems with the cow not wanting to go through the gate but I didn't have any trouble.
I fully agree with putting the gate and working chute under a shelter.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
