The release bearing should not "ride" against the fingers. Should be just a little free play before the bearing actually applies pressure to the fingers. If it is necessary to adjust it down against the fingers, something is wrong. The life of the release bearing will be drastically reduced, the clutch may slip under load.
You didn't mention replacing the pressure plate. That is usually where the problem is. When tightening the pressure plate bolts, they need to be evenly pulled down working an x pattern across the pp, otherwise the entire assembly can be warped.
As others said, it is possible to install the disc backward, but that results in the offset side of clutch hub rubbing against the flywheel bolts, which will cause the clutch to not release at all or make a terrible noise if it does release.
Other causes are the spline inside the disc is tight on the input shaft, or was damaged during the engine install. Also it is easy to bend the disc trying to get the engine splined back in, or damage the pilot bearing, especially if the engine is forced back in using the bolts. Hopefully you used an alignment tool. Trying to do a single disc without one is difficult, a dual disc is impossible!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.