I use a paint marker I like to draw :) I do this even if it already has a belt routing label on it and put it were I can see it while installing the belt. If I have to go under it or thru the fender well I draw it there also. Sometimes I draw it out on a piece of cardboard for reference. Most all belt tensioner's have a reference mark of were the belt should operate at I mark that also if I can get to it. Install the belt if it close to home you are good to go if not look it over you missed the mark somewhere are have the wrong belt etc.
Sometimes its located on the belt wrapper sometimes not... Before the internet you could have been chit out of luck. I don't remember the first one I ran across but a Jeep comes to mind and have seen more belt routing issues with them than any other.
Best I remember they were the first I seen were the water pump would spin in reverse rotation of the engine it thru folks lots of curve balls.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.