I built my own last month. I used a metal 55 gal. drum, I burned a bunch of 3/4 inch holes in the bottom, for drainage, then burned two rectangular holes in the sides, to allow a ford 3 pt drawbar to slide thru the barrel, about 1/3 of the way up from the bottom. Inside the barrel , on each side, I dropped a 3/4" bolt thru the drawbar, in the existing holes, and that was to capture the drawbar , so It couldn't work its way out of the barrel. I then made me two pieces of 4" angle with a 3/4" holes, for a top link pin, and bolted them to the top of the barrel, to serve the top link mounting. I put it on the tractor first, the drove over to the gravel pile, and proceeded to fill the barrel. If you make one remember to put the drawbar thru the barrel very low down on the barrel, to get adequate ground clearance, also use lengths of log chain, as stops, so your 3 pt can't drift down.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.