Posted by notjustair on March 02, 2017 at 18:56:38 from (184.191.48.136):
I'm looking for "conventional wisdom". I'm rebuilding the front end of the old truck - 35 Chevy 1.5 ton. My uncle chored with it for the last 30 years and had it all messed up. One of those "take the play out of the front end by cranking the tie rod adjustment all the way in" deals. You have never seen so much bailing wire and 16 penny nails used as keepers. What a hot mess.
I've replaced the king pins, drag link, and tie rod ends. Not having a starting point, what is general wisdom as to a starting point for threading tie rods? Is half way a good place to start from so I don't have to go so far to adjust toe-in? I'm used to doing old VW's, so I'm used to running toe in at just under 1/4 inch. How's that for something of that age? With bias ply tires and 80 year old springs I'm betting tire wear shouldn't really be a concern. It will just be nice to not have a full turn of play in the steering. It's been in the machine shed for the last two weeks getting a new front end and it's time to get it back out there doing chores!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.