Posted by Paul Shuler on February 20, 2017 at 08:10:24 from (170.29.1.10):
I was reading someone else's post a week or two ago about changing the oil in the rear differential of his pickup and how bad it looked. It got me to thinking I should do mine. I have done quite a bit of tractor hauling and made two long towing trips up and over the Rockies and I have never serviced mine. I plan to haul a tractor up to Red power this June from Springfield MO so I thought I should do it. Then I opened my manual and saw that they recommend doing it at 50k miles. Ooops I have 95K on my 2008 Duramax. So I decide to do that and the transmission fluid also. When I drained the rear I was surprised that it looked just as good as the new stuff I put back in. I was wasn’t going to do the front cause if I understand it right it only turns when in 4 wheel drive and with all the mild winters we have had around here I bet I don’t have 200 miles on this truck in 4wd. But to my amazement when I drained the front diff the fluid looked awful. Looked like about half water and it had a lot of fillings on the magnetic drain plug and the rear had none that I could see. I have owned the truck since new and know for a fact the front end has never been under water so all I can guess is its condensation from lack of use and never getting warmed up. I am glad I went ahead and changed it. I may try and remember to run the 4wd on gravel roads and such once in a while just to warm it up from now on. Lol, I'm sure nobody cares about any of this but I found it interesting. The pic is the ole Duramax and my best friend.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
