Posted by js305 on February 16, 2017 at 05:50:03 from (70.195.198.253):
In Reply to: Moving a refrigerator posted by rminon on February 15, 2017 at 18:27:19:
In 1972 I was given a five year old Sears refrigerator for the taking. Problem: It was 350 miles away and I didn't have anything to haul it with. So, away we went, intending to rent a trailer one way to bring it back. At the time I could rent a U-Haul (smallest) trailer for about $25 one way. Not bad even then. Not knowing any better we laid the thing down on it's back, the coils were contained underneath on this on. I looked at it and decided to duct tape the compressor so it wouldn't be dangling sideways on the mounts or coming loose.
After getting it home I put it in the garage and left it for a week so I could find something to do with my old one. This was not on purpose, just a matter of logistics. Moved it in and everything worked, until 2012, that is. Oh, I did have to replace the defrost heater and the timer one time, but that is all. 40 years ain't bad. Spent maybe $50 on parts during that time. Now it resides in my shop with the original chocolate brown decor as keeper for oil and other things. I did run some sealer in the vents so the varmints couldn't get in it. Never have had a problem with condensation either. Probably because it's inside my shop.
Two things about this story: In my case transport didn't hurt it, and the fact it lasted nearly 50 years. Find a new fridge that will be around that far in the future now!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
