Posted by Bill VA on February 11, 2017 at 13:29:34 from (216.24.76.146):
It's been a while since if been able to fully troubleshoot my MF50 diesel's starter issue. Went to start it probably a month ago and the battery was very weak, cranked over once slowly and then stopped. Went and got my battery jumper, hooked it up and before turning on the power, the starter tried, ever so slowly to turn the engine. It was as though the starter never disengaged. Glad the battery was already drained. I'm thinking switch shorted all the way. Bought a new switch (starter and solenoid are maybe 9 months old) and thought I'd try to replace the old one. Pulled the old switch out, tested it with a meter and as far as I can tell, it's good, no internal shorting that would keep the solenoid engaged.
Then.....
I do some internet searching and find it a common occurrence that on a DIESEL (regardless of make it seams - which is why I'm here and not the Massey section) when the battery is very low, the starter solenoid can remain engaged, trying - with whatever juice is left in the battery, to start net engine!
Why is this? I would think there is a spring to disengage the contacts on the solenoid when power is removed via the switch (which is why I assumed a shorted switch). Have I got it backwards on the mechanics of a starter solenoid and the springs hold the contacts closed and power from the switch opens/pulls the plunger into the springs, collapsing them and holding them and in doing so, disengaging the starter? Don't think that squares with my wiring diagram.
Why would a weak battery continue to cause the solenoid/starter to crank after the switch is removed from the start position?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
