Posted by ericlb on January 19, 2017 at 08:28:17 from (67.142.173.20):
had the farmhand loader off my jd tractor while i repaired the tractor and used it for some other things, went to put it back on, now ive had the thing off sever times and never had a problem re attaching it, until this time, first it wouldnt raise the front pipe up high enough so it and the rear loader frame would clear the pins on the side of the tractor, nothing has changed, it came off the same tractor, then after picking the rear up with another loader i got it sitting where it is supposed to, the long bolts wouldn't go up in the holes where they thread in on the rear, finally i removed the lower latches so i had a straight shot, threaded a 1 inch tap up there thinking maybe a mouse had crawled in there with a file and worked the thread over, they were fine, the bolt threaded in too, put it back together it wont fit, so i shoved the loader backwards with another tractor until the jd was sliding,to get more clearance, it still wont fit, keep in mind all this stuff came out of the exact same holes, finally i got it by driving the pins out of the lower latches and threading the bolts in, then using a steel bar used for setting the holes for beams on steel buildings i lined up the pins again and drove them in, have no idea what happened ,but before i remove it again, i think i'll scrap the tractor if i cant get to what i need to fix on it with that loader on
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
