Posted by notjustair on January 18, 2017 at 16:45:43 from (184.191.48.136):
As my mother used to say.
No one is willing to work on the ruptured disk in my back because there are others that will go soon. It needs to be done as a group thing I guess. My neck is kind of in the same situation due to arthritis and from years turning around in the tractor.
I have been getting injections in my spinal column to help the arthritis and calm the nerve roots that are being smashed. Today was the first of two procedures to fry the nerves going to five offending vertebrae. They do one side and two weeks later do the other. He's already done 15 different injections in various sites to improve my ability to function. It actually has really helped.
Holy smokes. I've never had such a painful procedure, and I've had quite a lot of things including colon resection.
He put in a probe for each vertebrae until he hit the nerve. Then he electrified it to make sure it wasn't the nerve to my legs (apparently that paralyzes you for a while). The muscles jump and twitch all the while making you nearly wet your pants with pain. Then he hooks up jumper cables and heats each probe to 175 degrees for 90 seconds. Two times. Of course this causes skin burns and other fun things. I couldn't see, but it seemed a lot like what happens when I break out the load tester on a tractor battery.
All this just so I can function and abuse my body some more farming and doing what I love. You have to love modern medicine.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
