Posted by Bryce Frazier on January 15, 2017 at 17:30:26 from (97.73.64.155):
Spent yesterday and a lot of today sanding on the truck. Pretty much ready for primer I think? Need to pull window trims, and do a little sanding / scuffing by hand here and there. As far as paint removal, I stayed away from the paint stripper. I read the can at AutoHouse and though "NO!". I just sanded. and sanded. and sanded. then I sanded some more! LOT of work, but it is going to be so nice when it is done!!
The 2nd picture is where the big crack was in the right dually fender. I sanded down to the plastic inside and out, and did a very thick layer of fiberglass on the inside, and a single layer on the outside. Set up really strong, looks good. I sanded that a little, and then a light layer of LiteWeight, and it is looking really good! Going to really burry that area in Primer, should cover it up once I block it down I believe.
All in all going well! Have decided that I am going to go to 19.5 Semi tires / wheels. I think it is going to look REALLY good when done! So excited! :)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.