Posted by Janicholson on December 24, 2016 at 10:08:38 from (97.112.61.225):
In Reply to: Re: My daily driver posted by coshoo on December 23, 2016 at 22:12:04:
The chassis is CJ3B The cab is from a 1949 IH K series 1.5 ton straight truck. History: As told by the son of one of the people in the story. Missoula Montana 1948, there was an implement dealer that had a customer base making loose hay in stacks. They used dump rakes to gather, and front end loaders (farmhand etc.)to stack it. The loaders used 10 foot wide fork tined "buckets" and trip latch. The Owner decided to make faster, bigger machines for the purpose. He purchased 5 IH 1.5 ton X 150" WB straight trucks to modify. Harvester would not sell the trucks without cabs because they could not transport them. So the trucks were modified by removing the cabs, Turning the differential upside down, re-arranging the steering brakes and clutch to work going backwards. The Lift was frame mounted and extended outside of the wheel base pointing backwards. A 16' wide fork setup was attached with trip system. Evidently the market was saturated as the total production was 5. 6 years went by. The next business on the street was a body shop. The Owner of that shop and the implement dealer were friends and often shared breakfast and coffee. The body shop guy had been looking at the 5 cabs sitting on blocks for all those years figuring how to use them. One day he broached the subject by suggesting they could make a weatherproof vehicle out of them by putting a cab on a Jeep. Good Idea. The duo Arranged that they would buy the Jeep 50/50 and the cab would be supplied free and labor supplied free. They purchased a new 57 CJ3B Willis, and put the cab on it. It was sold for about 2X the jeep original price as it was seen. Good to go, they did it again and the next was sold part way through construction. The third was sold before work started. They looked at each other and decided they each needed one of them, so the remaining two were kept. Mine was given, by the body shop owner, to his son. The one belonging to the implement dealer was (best I recall being said) sold to a hunting/guide/tourist camp in Redlodge MT. One was wrecked in and accident. One was left to rust after a failed engine. And one was rolled down a mountainside. I modified mine by using a Ford Ranger gas tank under a hatch in the "bed" (better than a 6 gallon tank under the drivers seat), and rack and pinion steering from a 1981 Toyota Tercell. It is immediately surrounded by interested people when in a parking lot. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
