I own a 1967 case 930 gasser book says about 80hp but it's over that I'd say 90 or so, it's a real lugging tractor, I can sink a 14 foot disk in the ground and have it idleing and she'll still pull it. It doesn't drink much fuel unless I start pulling a 5 bottom plow and such. Starts up everytime I use it, never any problem didn't use it much last year sat for problably 7 months, I got on it it rolled over twice and fired right up. My favorite tractor by far. I have seen people really complain about them about being gas suckers but I live in Michigan, I also have a case 1030 diesel and you can't hardly start the darn fool up if it's 40 out let alone in the winter. It really saves the hassle when getting logs in the winter for wood. Always loved the old gasser tractors everyone has a diesel and turns Their nose up at a gas, but I'm just the opposite, it might cost more to run a gas but when it comes tune up time what really costs you then? Plugs, wires, cap, rotor all done.... my neighbor used to have a 1755 Oliver gasser he used to love it for the same reasons regrets ever getting rid of it, a close family friend had a 930 gas like mine and he used to sink a field cultivator and all kinds of equipment behind it and on and idle he could carry the front end off the ground. Know a farmer who's got a 4020 gas he's had since his father bought it new in 1964 he's got a loader on it and he says he wouldn't trade it for the world it's his favorite tractor for once again all the same reasons. Hope this helps
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
