Posted by caterpillar guy on December 04, 2016 at 18:47:54 from (75.128.155.236):
In Reply to: Another bin question... posted by Dave H (MI) on December 04, 2016 at 09:06:24:
I would go with more capacity than you think needed now as if you expand some you still have room. Alos as has been said the shallower the grain the easier it will be to move air through it. If you decide to go with 2 bins have them the same size so sweep augers and such are interchangeable. Check out how much electric service you have as if you decide to go with a dryer it will add up fast for amperage requirements. If you have a place with 3 phase it would be better to put the bins there as the motors are cheaper and will be easier for the dryer you should choose. 8 inch load out augers for the bottom will also not be regretted. We changed ours to that. If you have somebody come in to load in the winter or other time they will start with detention time for longer loading times with the 6 inch. Most like to load in about an hour or less. I would not get a bin again without an air floor in it. If you get the air floor do not get that chisel or hawk cut floor it sucks to sweep when finishing cleaning out. Get a preferated floor that is smooth. We have one from Golden Grain that is smooth and has been nice to clean. it is in an old butler bin. You can shop for floors different than the bin manufacturer. Get the walkin door not that little square crawl in door. You will regret it the older you get if you don't. I am looking for a walkin door for one of our bins. And you are welcome to come look at our bins if it will help with your decision. I'm in Shiawassee county only about an hour from you and a mile and a half east of M-52
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
