It's always good to have dreams, but it is also vital to be realistic. If your interests are still spread between engineering, running a machine shop and farming, take the time to work out a plan, a budget and a timeline of what it will take to get established in each field. Then talk to people in those industries to fine tune those plans.
Take a good look at the condition of your machine tools. If the ways are starting to rust or the spindle bearings are getting a little rough or loose, it may take some big time and big money to get them back into condition to hold decent tolerances. Chucks, collets, cutting tools, jigs, fixtures and sharpening equipment will also be needed. The capital investment in a machine shop can add up even faster than for farming.
An engineering job, in your home town, with an employer that does not mind you taking time off during the busiest part of their projects so you can plant corn, bale hay or feed calves every night, is extremely unlikely. In engineering a reluctance to travel when needed or to not do what it takes to get the projects done on time and on budget can be a seen as a big handicap in the eyes of a potential employers. Talk over your plans with your academic advisors or your school's department head.
I would advise anyone just starting out to pick a main career and concentrate on doing that very well before trying to branching out into other businesses. Good luck and please keep us posted on your progress.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.