Posted by Adirondack case guy on December 01, 2016 at 16:08:18 from (74.69.160.79):
Been doing a lot of pondering on how to fab up the hyd dump on the new wood hauler. Started out with using one or two old SA cylingers off an old loader that I had. then my focus turned to an old 4x36" DA cylinder that was on the first wood splitter that I built. Dad ran it for years until the I beam rails wore out and the wedge came of and bent the cylinder rod. I salvaged the old DA cylinder that had sat in the woodshed of the saphouse for probably 20yrs and finally got it pulled it apart with my trackhoe and straightened the cyl. rod. My good friend Jon-MN and I have been discussing posabilities and he gave me some sugestions so That I can get 6' of lift from the 3' cylinder. Original plan was a deadman on trailer toung and pully on clevis of cylinder rod, and then attachment point to bottom of dump body, connected with a cable. The problem was that the hyd hose ports were pointing forward and the cable would be interfearing with the fitting and hoses. I ended up deciding to use #50 roller chain instead of cable and fastened the deadman bracket to the top of the cyl. so the pipeing and hoses are free from the chain, plus it will take half as much chain. After fabing the deadman bracket to conform to the outside of the cylinder, it will be welded to the top of the cyl. I remenbered that I had some HD bearings stashed away so I dug them out and built a "toggle bracket with 2 of the bearings for the chain to feed over the rod clevis as the cyl extends. With this design the bottom of the body will be raised 6' when the cyl is fully extended, rather than just 3' if the cyl. was directly connected to the body. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
