Posted by lenny23lenny on October 25, 2016 at 16:42:40 from (184.20.96.39):
I partially give up. I have a 7700 Ford tractor. The idler pulley broke. I went to TSC got new bearing put it all together and was feeling pretty good. It is held on bracket by a retaining ring.
Part of the bearing was stuck on the shaft. I got it off with a grinder and was still doing pretty good didn't get into shaft so far so good. Then I tried to put the pulley back on the shaft. It would not go. I tried cleaning up top of shaft. Still would not go. Bearing was 5/8". Then I got aggravated and more aggressive until I messed up the shaft. I think I can remove the shaft assembly and replace it if I knew what it is called. It is welded to the bracket. Main question is it referred to as shaft, stud, bolt or what. I know that is what happens when you loose patients. Should have walked away. New bracket is 129-287 dollars.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
