Posted by fixerupper on October 18, 2016 at 20:43:26 from (100.42.83.79):
In Reply to: Case SC vs JD B posted by Tom RS on October 18, 2016 at 18:44:33:
Well I'm an old dyed in the wool two banger guy, but I have owned and SC for 41 years and to be honest when I want to hop on a small tractor to move something the SC gets the nod 90 percent of the time, mainly because it is easier to get on and off the SC. It's one step up, swing your leg over the seat, sit down and go. The SC has a smoother hand clutch than a two banger but the two banger has far superior brakes. The brakes on a B have to be very, very bad to equal the best SC brakes. Reaching down to operate the brake lock is equally unhandy on both tractors. The B steers shorter and is a little more nimble but the SC steers a little easier. The SC has faster hydraulics but that pilot operated relief valve is annoying. If you are driving it all day long a late B will be less tiring because you can squirm around and change your position in the seat somewhat. You can leave the SC idling forever without worrying about shifting to neutral and pushing the clutch in. The SC will have more power at idle or near idle for putzing around. A muffler is MUCH easier to replace on the SC. Dependability wise, they are both equally very dependable tractors with routine tune ups. I don't have any experience with the pulling power of an SC compared to a B.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.