Posted by RBoots on October 16, 2016 at 11:48:33 from (173.241.113.102):
I have a Farmall 460 D that we bought after it suffered from an electrical fire. It had set for a year or 2 after the fire. I believe they had pulled the battery cable off to stop whatever caused the fire, and then used water to put out the loom,chaff,grease,etc. I rewired it, got it running, but had to pull start it, as the starter would turn, but had a huge amp draw. Well, I tore the starter apart, and it was solid rust inside. I believe that when they sprayed water on it to put the fire out, it got inside the starter and just laid there, rusting it over time. I took it all apart, and laid it out in order, cleaned up the brushes, sandblasted the housing, the brush holders, and the metal parts that hold the "windings"(can't remember the proper name), to the housing. I'm pretty sure I got them back in the right way, I was told they have to go a specific way, but I may have got them mixed up during reassembly. Anyway, I checked all the electrical parts for open circuits and/or for being grounded out. I put it back on and it spins GREAT!!! Only it spins the wrong direction now... Did I somehow get the brush and or brush holders hooked up the wrong way? I'm usually pretty good at understanding how a starter and electrical stuff works, but it just seemed that all of the brush holders went back only in one spot, and wouldn't go in any other spot. But I'm not an electrical engineer or electrician like many of you either. Thanks!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
