Posted by Leroy on October 14, 2016 at 06:30:28 from (69.88.202.2):
In Reply to: combining difference posted by Keith Molden on October 14, 2016 at 04:02:00:
Keith, we are in opposite corners of the state, northwest Ohio. Nobody swaths here. Years ar on red clover it was popular but in doing that I saw all the seed we were losing and was able to talk Dad into direct cutting, yeald was way higher direct cutting, just had to dry on flat bed wagon for a week or sow. Only put in to a depth of about 4" and twice a day would go out with the scoop shovel and move it around. Have done that on concrete floor as well but wood wagon was better. Big time operator neighbor thought he was going to be smart do that to his wheat crop to get earlier start to double cropping soybeans. He lost his but on that. As soon as he had in swath the rains came and came and came, the wheat sprouted in the swath and was unharvestable. That is the last time I have ever heard or seen of seed or grain being put in a swath. Only thing in a swath is hay and those machines are not swathers as they have conditioning units on them that a swather does not. The only swather I ever saw and I am 73 was the unit that you put on the bar of a bar mowerjust slid the crop into a row and they were only used for grass seed. Never saw one mounted let alone used. No red clover raised anymore but it used to be main hay crop for all dairy farms, no alfalfa, and swathing it for the seed went out 60 years ago.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
