Not knowing how much air you need it isn't possible to be specific. You can't do much better than Campbell Hausfeld. I've had a Speedaire compressor, made by Campbell Hausfeld which I've been using since 1988. I just had a little compressor I bought from Harbor Freight go down this week which was very portable. I had been using it for 20 years. Tractor Supply had a 10 gallon Jobsmart compressor on sale about the same size so I bought it. When I unpacked it I was startled to find out the pump and motor was the same as the Harbor Freight compressor.
What I don't like about the trend in compressors is they are making most of them vertical now. It may be nice to move one out of your garage down the driveway but I can't see hauling one in a truck. The way people drive today swerving in front of you and slamming on the brakes, I don't know how you could keep a vertical compressor vertical. It's difficult enough to keep a horizontal compressor from turning over. I don't like oil-less compressors either. Any I've ever seen are very loud and the couple I had wore out in a year.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
