Is your header setup for Dial-A-matic?????If you only have a three wire plug then your header is still setup for the older limit switch control. You can make the Dial-A-matic work with a toggle switch header but it take an adaptor harness and then you only have ONE setting not the multiple ones.
Look on the right side of the header. The control rod runs across the header at the back of the flex sheets. IF the header is set up for Dial-a-matic then there will be a black sensor box hooked right to the end of the control rod. If there is a linkage running up to an eccentric that operates two micro switches then you have the older toggle switch header.
If you have the Dial-a-matic box then lifting the indicator rod will not cause it to lift. The bottom part of the linkage just pivots on the shaft the turns the control box. The older toggle headers would raise but not the dial-a-matic ones.
You should be able to hear the header control solenoids working as you cut beans. They make a bumping sound as the header works.
If you have the correct control box it may just need adjusted. Look at the mounting bolts on the box/sensor. One of them goes into a slotted hole. Loosening this bolt will adjust the range that the control box works in. If it is set too far one way you will not have all four settings.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
