Posted by Leroy on October 04, 2016 at 08:33:02 from (69.88.202.2):
My 2003 Dakota with 4.7 engine sat it started fine and moved it about 15' away from barn door and shut off. got tractor out and was ready to use it to load trailer hooked to truck. Went to start truck and turn key, nothing. Lights all good and bright, only one on dash not working is gear shift position indicator, automatic tranny. Battery cables clean and tight. Battery on load tester checks good and jump start makes no difference. Turning the key makes no difference, hear nothing. Just like a wire would have droped of terminal. Do you think a starter can fail like that or could it be something else. Friend was out and thinks starter and tried reaching down in tight spot and tried tapping starter, nothing. Always when I had any starter trouble you would notice something ahead of time it failed completely so can they go out just like that or not? Have not been able to get ahold of my mechanic friend that helped me buy the truck. He just a couple of hundred miles ago replaced the exaust manifold and steering coupler. To do that would he have had to have taken the wire to seloniod off in that it might not have gotten tightened to stay on? Or do you think it might be switch went out all of a sudden. One time perfect then half hour later nothing.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
