Posted by rrlund on September 25, 2016 at 10:55:14 from (162.250.24.40):
When I asked a month or so about commercial radiator cleaning products,somebody mentioned vinegar. I drained the radiator and block on the 2-135 a week ago today and put three gallons of vinegar in it and topped it off with clean water. The antifreeze that I drained out looked like new from start to finish. I chopped with the tractor all week,then drained it out this morning. The stuff from the radiator was kind of black,more so at the start than the end,but the stuff from the drain plug in the block looked like thin used oil. I stuck a hose in the radiator and flushed it for 15 minutes or so until it looked fairly clear,then I filled it with water with some baking soda in it to neutralize the acid in the vinegar. I figure I'll run it for a day then drain it,flush it and put the anti freeze back in. It was running cooler than it had been. Enough so that I'm not real concerned. It didn't cool it down as much as recoring the one in the 2-105 did for that one,but good enough for now. My son said they run stuff in the race cars that keeps them cooler. Something like Water Wetter and some Purple something. He said it's best with distilled water. Said it'll bring them down 20 degrees. He said it's not as effective with a 50/50 antifreeze mix. Said about 10 degrees with that.
Gonna be interesting to see what the water looks like when I drain it again after running it a day though. I was expecting dirty water,but not black like that.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
