I was in a sheet fed shop for 8 years, mostly Heidelberg's.
1, 2, 4, 5, and 6 color presses 28 and 40 inch machines did a lot of high end work annual reports, artwork, prints, posters etc,
If we got wound up to 12 000 sheets per hour we were flying.
From the day I started we were putting in 75-80 hour weeks, made lots of money but had no life.
The day the 2 color started up on its own while I was cleaning the plate gap was the day I walked away from the trade, I heard the click of the contactor and pulled my arm back just in time as it tore the wrench out of my hand in the process.
All safety's and stop bars were engaged at the time, the Heidelberg technician figured a contact had welded itself and when my arm wiggled the safety bar it set things back in motion.
Regardless it was the day I walked out the door for the last time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.