Posted by sotxbill on September 03, 2016 at 06:55:33 from (104.5.24.112):
In Reply to: One Wire Alternators posted by Indiana Ken on September 03, 2016 at 06:21:53:
A generator has a permanent magnetic field. So all it takes, it to spin it up to a high enough speed to make the requlator kick in... You can always pull start a generator tractor with a dead battery, as long as the battery is not a short.
An alternator must use battery voltage to create a magnetic field.. so it can never start by pulling with a dead battery.
A one wire uses an tiny amount of electricity to put and keep... a very small magnetic field on the alternator,, and spinning it up to a high speed to finally sense enough voltage to kick in a charge,, very similar to a generator.
A conventional alternator using the ignition sense lead to turn on the alternator and magnetize it so it requires a working ignition lead through a diode or warning light to activate it. It does not have the bleed resistor in it. This type will charge as soon as it it spun... does not require to be spun up to a higher speed to start charging. And it will not have a small bleed current when turned off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.