Posted by Dave in GA on August 29, 2016 at 17:37:56 from (162.196.195.8):
In Reply to: Truck Rant!!!!!!!!!!! posted by Bill VA on August 29, 2016 at 12:35:49:
Bill, I couldn't agree with you more. Why do the new pickups, even the half ton 2WD ones, have to be so ridiculously tall? I know the truck manufacturers are all trying to outdo each other with the most manly, brawny, tough-guy, unstoppable ginormous monstrosities, but if they get any taller and more bulky, they will be right up there with Peterbilts and Kenworths. Whatever the fad is called, it's not for me. Make them reasonably sized again. Makes me appreciate my beater 1971 International 1/2 ton with 304 and 4-speed and 8' bed. The top of the sides in the rear is just under 48 inches! Perfect height to lean on to chat with somebody holding a cold drink. I can reach into the bed almost to the center. Yet this truck will haul a lot.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.