Posted by UP Oliver on August 13, 2016 at 09:17:11 from (68.70.134.87):
Hello again.
I just put a jumper wire from the battery to the starter. I put the positive on the positive post, the negative on the negative post, the other end positive on the starter and the other end negative on the ground on the engine block. Major sparks, but I heard the engine turn over. So I tried it again and just touched the negative on the engine ground and the engine turned over. The key was in the off position.
Then I just hooked up the positives, and nothing happened. I don't understand this though: the negative cable on the battery goes to the bolt on the engine block, so why does the engine only turn over when I hook up the negative jumper cable from the post to the ground bolt? The existing cable that is there does the same thing correct? I bypassed the solenoid and got it to turn over, so I am thinking the solenoid is shot. But I don't understand why the negative jumper wire caused it to turn over and the existing cable on the tractor does not with the postive jumper cable hooked up. I cleaned my connections, just don't get it.
Thanks again for all the help and sorry if I am a little (or a lot) slow on this topic.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.