Posted by rankrank1 on July 30, 2016 at 07:39:17 from (166.137.12.122):
In Reply to: powering a welder... posted by 88-1175 on July 29, 2016 at 23:25:37:
A Lincoln AC 225 buzzbox was recommended to be wired up on a 50 circuit but they do not pull anywhere near those amps. I had mine on a 40 amp circuit and never tripped the breaker even wide open. W
Many people easily run them on the most common welding settings off a 30 amp dryer circuit in rental homes where running a new circuit is not an option due to non-ownership.
While I might not buy a generator that small to purposely power the buzzbox, if I already had the generator I am pretty sure I could get some 1/4 plate welded up even if I had to resort to 1/8 6011 rod on a low amp setting on the welder. (7018AC or 7014 would require a slightly higher amp setting on welder to get same job done).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.