Posted by Ron-MO on July 29, 2016 at 09:14:47 from (174.131.235.238):
In Reply to: OT Shared wells posted by delawaresurfman on July 29, 2016 at 08:59:51:
While I do not have any first hand experience with a shared well, I have found it is best to control as much of your utilities (well, septic, etc) as possible, then there are no issues or arguments. I moved from living in a small community where I was on city well, sewer, and even had to pay for trash pickup (whether or not I wanted to or not). I now have my own well, lagoon, dispose of my own trash, and the only utilities I have to worry about is electricity. I do use propane, but own my own tank so I can pretty much control who I purchase that from as well. About a year ago I dropped Dish Network and have not regretted that either. Others will have differing opinions, but I would want my own well and septic system if at all possible. Before I moved I was facing replacement of my sewer line, and found the main was in the middle of the street. To replace the entire line meant digging into the street, and my paying to repair at a cost of approx. $500 just to repair the street damage. The bad part was that historically the city took years to repair, and everyone drove over the potholes in the meantime until some crew had time to toss some cold mix on top even though someone had paid good dollars to repair. I got by till I sold, and for the life of me I cannot understand why I lived there for as long as I did and put up with the nonsense. I guess I like to control my own environment, and the least amount of outside (government) control the better.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.