Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: Ferguson to20 pto (new tractor owner)


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by W_B on July 26, 2016 at 10:37:15 from (155.188.183.20):

In Reply to: Ferguson to20 pto (new tractor owner) posted by 7242337 on July 25, 2016 at 20:09:37:

There was quite a bit of discussion about pulling things with a tractor in another post here recently. But bottom line is, never, ever ever pull from any point above the axle. I have a 9N and an 8N. The 9 has a draw bar that attaches at to the lower three point hitch arms with stay bars running up to the top link attachment point and sway bars to brackets under the fenders. The 8N has a dedicated draw bar that runs under the "pumpkin" and stays on the tractor for most uses (if I recall it has to come off when the brush hog is used). I'm not familiar with the Fergy but it would use either of these systems, probably the 3 pt. bar. If pulling a log or anything for that matter, make sure the front of it is off the ground. Should it dig in you could get a nasty jolt, break something, or worse, a back flip of the tractor. It would happen so fast you'd be dead in a second.

Similar issue with running on hillsides, creek banks, ditches... you can flip it over on yourself if not careful.

As far as the PTO shaft, never, ever, ever go near it until it has completely stopped turning, especially on a brush hog, lots of momentum in those blades. It can grab you and pull a limb off or suck you in to severe injury or your death.

Oh, and NO riders! How horrible to see your kid or grand kid slip off and disappear under a wheel or under the brush hog, you'd never get stopped in time.

Properly used these old tractors can be reasonably safe and productive for you, but use your head.


Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial # List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy