Posted by iatractorkid on July 24, 2016 at 10:12:03 from (184.97.47.71):
Hey guys! Wanting to mount a battery to my new flatbed for the winch. Trailer is a tilt bed and I would like to mount it inside the frame, under the bed. That will give me access to it when trailer is tilted but out of the way otherwise. I am looking at the Southwest Speed #499-903 bolt on box, and the Torklift HiddenPower mount.
Both will fit the Group 24 deep cycle I'll be using.
The Southwest Speed is alot cheaper, but I'm not sure if the battery should be "protected" inside of one of the molded plastic boxes. What do you think?
Torklift HiddenPower is a nice setup, and comes with the plastic box, but is made as vehicle specific so I'm trying to get in contact with them to see if any of their models will fit a 2x5" frame rail.
Also, can I splice into the 12+ wire charging the break-away battery through the trailer plug and extend it to charge the winch battery as well?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.