Posted by Janicholson on July 23, 2016 at 11:59:50 from (97.112.56.175):
In Reply to: DIY shallow well? posted by Moresmoke on July 23, 2016 at 11:23:05:
If the sand goes down to a source of water, it is sure possible to use water pressure to blow a hole for a new casing. But you need a lot of water to do it. We used the method on sand to blow holes 18 ft deep for steel Z section break water installation on Lake Michigan. The pump was a 12 hp 2 inch discharge. The connection was using fire hose connected to a 4' long 2" steel pipe. The holes were blown to about 25 inches in diameter, then the steel was lowered into it locking to the last piece. Continuous flow is necessary, I would think the pipe would need to be premade as long as you wanted the well to be in depth. Once blown to depth, a sand point of 100 mesh of 1.5 inch diameter was driven out the bottom against a drive coupling that stops the point from extending past tha casing. Driving a well in sand might be an easier option, Utube the process for that. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.