Posted by notjustair on July 12, 2016 at 19:33:56 from (70.195.9.241):
This year has been breakdown heaven. If bad luck were pennies I would have a sock full to put myself out of my misery.
I had an order for 1500 square bales. I mowed the front brome patch and the big field out back. The first 500 up front went fairly smooth and only broke a sheer pin when the side tire fell in a hole and bound up the tines.
Yesterday was different. The guy hired a guy I know to haul bales with his bale monster. When someone is waiting on you bad luck happens. He filled the first load and had just left when the 24 T quit tying on both sides. I looked and found that the tucker arm drive was bent. I quick called Chuck who retired from JD as their baler mechanic. He is able to fix anything. Chuck drove out and we took the shaft out and heated it and bent it back. He adjusted everything and I went back to the field. Chuck walked behind the baler and was right there when it did it again. Back to the shed. This time we realized the stop for one side had broken off allowing the tucker to go over center and putting it in a bind (at this point the bale monster was back and waiting). Chuck straightened the bend again and I welded on a piece of stock to give it a stop. He put it all together again and walked behind her and made sure all was well. She cranked out the rest of her bales without fail.
Did I mention Chuck is almost 81 and worked for Deere for 61 years before retiring last year? He was working a little slower yesterday - he just got a new titanium shoulder.
I wish Chuck had not retired so early. Of course, he still loves to come to the farm and I make it worth his time. I would pay him to come and tell me stories of his years with JD. Luckily they start flowing every time he has a wrench in his hand.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
