Posted by notjustair on June 20, 2016 at 21:07:32 from (70.195.1.134):
I'm still madly trying to get beans in. The wheat is ready of course. So today I put my partner on the combine and she cut while I planted. Of course the combine broke down twice. Nothing major.
Here's the puzzle. I use a Raven Cruiser 2 GPS to plant. I plant with markers as well. Basically I do my headlands and then snap the line with the GPS. I do this so spraying is easy and I can set that GPS to follow this one. After that straight line is set I just use the markers. I can plant much straighter with markers but leave the GPS running to track acres for seed refill. Both times the combine broke down I idled the tractor down, left the GPS and seed vacuum running, and went to fix the combine. Took a good chunk of time each time. When I left the tractor it was in the neighborhood of .2-.4 off of my snapped line. I have never known whether that's degrees or what - guys with GPS units will know what I mean. It's the deviation from parallel with your straight start line. Anyway, when I came back each time it was suddenly 2.2 - 2.4 off. I ignored it that pass and used my markers and within two passes it was back to normal - the whole numbers had corrected themselves and we're back to partials. It seemed the longer I was gone the more off it was but always in whole numbers.
I was totally puzzled. I'm thinking maybe it's because of the Earth's rotation. Is that realistic? The tractor is in a different position in "space" even though it hasn't moved. Plausible?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
