Posted by Leroy on June 20, 2016 at 06:46:58 from (69.88.202.229):
In Reply to: swinging drawbar posted by wally b on June 19, 2016 at 20:38:55:
Goes back to the drag type implements and being able to turn at the corners and the earlier tractors did not even have brakes let alone turning brakes. And the farther back of the axle center the harder to turn under a load and if you look most had the drawbar quite a ways back of the axle, a few had hitch direct against the differential housing like the orignal Fordson of 1918. And they would still with the disk that stayed in rhe ground all the time wanted to slide the fromt end sideways and outfit keep going straight. The swinging drawbar took care of that. The Farmal F20 did not have a swinging drawbar so they made it to automatically apply a brake on side you were trying to turn to so it would make the turn without sliding front wheels sideways. About the first wheel carried equipment was the grain drill and that did not put the load on to make problems turning but if left in swing position if eithe wheel would hit a clod it would whip it to that side and you could not get a straight and in place planted strip. Same aplies to wheel carried disks with the wip around and most are raised to make turns so no reason to let swing and wip around but if left in ground you would let it swing to make that turn and hope it did not wip around too bad the rest of the time.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.