The one I put up last Spring is 40x100 and is oriented east to west. On the west side are my two big doors, 16' high and ten wide each, that the combine and other equipment go thru. I pull equipment just inside these doors to work on it. Lots of light and air, no rain, snow or sun. On the south (long) side is a 12' slider and this is used to move smaller equipment in and out when I have a big project on the west end. This is also a nice place to eat lunch or bask in the Spring sun whilst taking a break. On the east side is a small 10 x 10 slider. The land falls about 2-3' from west to east so this door opens onto a dock that can be used to load/unload my trucks without lifting. This door provides a lot of cross ventilation and morning light also. All the doors have great views of the fields making it a pleasant place to work. I am not really a great believer in solar in Michigan except for maybe heating water or pools. I also do not like those opaque panels for light. I have a lot of light without them. There are no windows or doors on the north side as a lean-to is planned to shelter some of the tillage equipment, etc. This works very well for me, I have no complaints.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.