Posted by JF in MI on May 31, 2016 at 16:46:00 from (67.133.147.143):
Since I know this forum appreciates rather than condemns a chronic cheapskate I thought I would post this. I got in my truck to go somewhere this morning and when I closed the door it just didn’t feel the same as the previous 25 years and required a hard slam to get it tight. It was also rattling. I’ve always maintained it in perfect condition and was PO’d that I would have to take the latch out. Just before removing the inner door skin I noticed some debris on the floor and realized that the plastic bushing on the door post striker pin had shattered from age. Well, I had some delrin and could have spent several hours milling down a bushing but decided to shop for one online. Best price I could find was $7 for one or $7.50 for a pair. More than the price for the small thing I just didn’t want to wait a week for it. But then I remembered some plastic electrical conduit I had. No luck, the ID was too big as was the OD and the wall thickness was a tad too thick. But then I thought; “wait a minute, that conduit is heat formable!”. Clamped a piece in the vise, heated it around with my HF heat gun, inserted the chuck end of a ˝” drill as a mandrel and stretched the pipe over it. Cut the section out and perfect ID, OD, and wall thickness. Even the color matched! I was so happy with my “skin-flintness” (saving $7) that I decided to pour myself a drink even though it was the middle of the day. When I finished my wife came home and told me she spent $150 at the local green house. I then had to pour myself another drink to drown my sorrows.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
