Posted by Geo-TH,In on May 26, 2016 at 18:18:01 from (172.78.4.145):
In Reply to: flat tire on the Ford posted by larry@stinescorner on May 26, 2016 at 18:05:08:
Larry, I don't have the strength to attempt to take a tire off the rim. I would have used the terramite to put the tire in the truck.
A tire place 30 minutes away is cheap and experienced working on tractor tires. They Cleaned up the mess inside the rear tire on the terramite. Removed the tube, Removed 5 plugs, put patches inside tire. Use right angle grinder with wire brush to clean rust off rim. Put bead seal on rim. Put in a new valve stem. Pumped slime in tire. And I shouldn't have to worry about flats until I cut the side wall. A tire that size cost me $48 to fix. It took them 30 minutes to repair. total 90 minutes. And I was feeling no pain.
Previously I spent $30 for a tube. It lasted a month before going flat.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.