Ian, Most here are on YT are Donalds, they resort to bullying ta tics instead of really addressing the real issue. WHAT REALLY CAUSED THE ROOF FAILURE?
It hard to get in site here, only poor installation, sheriff sitting on his butt.
The video on the news showed all the panels were rusty, plywood had mold so did the insulation.
All roof have something in common, moisture. All roofs need ventilation. Where are the air vents? eve vents? roof vents? ridge vents? Power vents? How do you get the trapped moisture from between the plywood the metal?
On the way home, I went past a metal roof that has been covered with tarps. Well, two guys were removing the old roof, exposed the rafters and perlins, both were dark with water damage. They were screwing new barn siding on the roof. Are these guys fixing the issue? Was there problem condensation, fastener failed or something?
Wish people commenting would discuss the issue instead of saying I'm a metal hater. You may be surprised what I really think. George
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.