Posted by JD Seller on April 28, 2016 at 19:57:49 from (208.126.198.123):
A few weeks ago I wrote about my wife shooting some clay pigeons. She mentioned that she missed shooting shotgun. Also she talked about how she loved the "feel" of her Dad's Benelli shot gun. So I got in contact with a gun nut buddy of mine that is a gun smith. He makes his living buying and selling guns of all kinds. I bought her a matched pair of Benelli 20 gauge pump action shotguns. She has an older Remington 1100 16 gauge she had "sized" to her so I took it for him to measure and make the new shotguns to match it. I also got a hold of all the Grand Daughters. They have scheduled time at a local range this Sunday afternoon. Women only. LOL
The wife just about deafened me when she opened the box the guns came in. She can squeal like the teenage girls still. LOL She had to shoot them some. Even thought it is rainy this evening she stood in the shed door way with me hand throwing some clays out into the pasture. She sure did not miss anything after the first few throws. She has them both apart on the kitchen table cleaning them and oiling them up to her standards. Also the Grand Daughters all had to come see them too. LOL
I bought her two cases of ammo thinking that would last her awhile. I was wrong, as usual. She just ordered more from my friend. She is going to get it tomorrow.
I might have created a monster!!!!! They are already talking about some summer "skeet" meets they may enter.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
