Part of my answer is, it depends. The tractors we use in the field are mostly equipped with radial ply tires. When used in the field for tillage, I try to follow the recommended pressures based upon the load, or weight carried, on the tires, as well as maximum speed. On our large tractor, with 18.4 x 46 radial tires, the per tire load amounts to about 4000 pounds per tire since this tractor has duals. I am running around 12 psi in those tires, whereas the 14.9 x 30 radial on the mfwd require 28 psi. If running singles on the rear, then the pressure needs to be higher, but I cannot recall off the top of my head what it should be. The 2 wd tractor used for planting and planting is set up with duals, but these come off when hauling grain in the fall or chopping stalks. I think we might pump the singles up to somewhere around 20 to 24 psi. On the tractor with bias ply tires, they are not used for pulling heavy draft implements in the field. We run those a bit higher simply because, as I recall, bias ply tires are not designed to run with lower inflation pressures. Our "classic" tractors run with bias ply tires and they are pumped up similarly to our other tractors with bias ply tires. Again, for actual use, I tend to follow the recommended inflation pressures from the manufacturers based on the weight/load on the tire and the ground speeds I will be running.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
