Posted by hillbilly2 on April 16, 2016 at 19:49:56 from (70.194.14.115):
Today I started up the Ford 2610 diesel to warm it up to change the oil. I pulled it in front of barn and thought I set the parking brake. Then I did the same with riding lawnmower. I went in the barn and moved a few things around and then noticed I could only hear the lawnmower running.
I looked outside and the Ford took a nose dive into the pond while running at about 1200 rpm. The water was about 4 ft deep in that area but it was enough to suck water in and kill the engine.
I pulled it out right away and put it in the barn and started tearing the engine down to pull the head and pan off because I could see it had blown the head gasket out when it sucked the water in.
One I got the head off I moved each piston to TDC and used a straight edge and feeler guage to measure height from deck to piston. #1 and #3 are both the same (about .008) and #2 is about 45 thousandths lower.
I would assume that means it has a bent rod. It still turns over fine, but I am wondering if it would be safe to run it that way or did it weaken rod and lower compression too much?
Sorry no pics. I had it out of the water in less than 5 minutes and knew it wasn't going to be a moment I wanted to remember.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
