A family member farms under windmills and he loves them for their extra income. None are located close to his farmstead. The devil is in the details, so read the offer carefully, ask a lot of questions, counter offer, and remember that anything not in writing on the final agreement will never happen.
Some questions I would ask are:
What are the payments for: the leasing right; when construction begins; annually for the life of the unit, at the end of the units life. What specific locations do they want to build on? What happens to the topsoil that is removed? Minimum setback from farmsteads, line fences, roads, neighbor's houses and other windmills? Do you have the right to reject any locations you don't like? What are your rights if the company builds on your neighbor's property and not on yours? Are annual payments fixed or indexed?
At the end of the windmill's life: Will all the equipment, foundations, access driveways, and the buried cables be removed? Will the topsoil be replaced? Will the company retain the right to install another windmill without a new agreement?
You would probably have the best bargaining rights by negotiating as a group with other farmers.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.